Humidity Calibration Kit

For a quick humidity check

The humidity transmitters as all other measuring instruments shall be periodically checked and eventually adjusted. The most simple solution for this purpose is the E+E Humidity Calibration Kit.

Inquire now
  • Humidity
Calibration chamber
Calibration chamber
Humidity Standard Set
Humidity Standard Set
Calibration Certificate
Calibration Certificate

The E+E Humidity Calibration Kit is a cost effective solution for calibrating humidity measuring instruments with sensing probes Ø 10-12 mm (0.4-0.47 inch). It is very easy to use and it does not require highly qualified technical staff. The kit consists of a humidity calibration chamber and a choice of E+E Humidity Standard Sets. 

Humidity Standards

The E+E Humidity Standards are non-saturated salt solutions available in sets of five or fifty single-use ampoules, which may be stored an indefinite time. The salt solutions are non-harmful, handling them does not require specific safety measures. Safety data sheet is available upon request. Each E+E Humidity Standard Set is supplied with a traceable calibration certificate, issued by the Austrian National Metrology Institute (NMI).

You want to know more about our products?
We are looking forward to help you.

Inquire now

Technical data Humidity Calibration Kit

  • 0% RH ... ±0.3% RH
    5% RH ... ±0.5% RH
    10% RH ... ±0.5% RH
    20% RH ... ±0.5% RH
    35% RH ... ±0.5% RH

    humidity value in %RH ... accuracy at 23 °C (73.4 °F)

  • 50% RH ... ±0.9% RH
    65% RH ... ±0.9% RH
    80% RH ... ±1.2% RH
    95% RH ... ±1.2% RH

    humidity value in %RH ... accuracy at 23 °C (73.4 °F)

You want to know more about our products?
We are looking forward to help you.

Inquire now

Downloads Humidity Calibration Kit

Datasheet
Humidity Calibration-Kit Datasheet
(428.89 kb)
Manual
Calibration Kit - User Guide
(1042.14 kb)

Humidity Calibration Kit FAQ

  • What is the difference between a 2 wire and a 3 wire current output?

    Transmitter with "two-wires" technology receive the power from the process, and the signal is carry on return wire (closed current loop). With technology "three-wires" the power supply is separate from current output: 2 wires are the power supply and third carry the signal.

You want to know more about our products?