Welcome to E+E Elektronik – the sensor specialist for humidity, CO2, moisture in oil, dew point, air velocity, flow, temperature and pressure.
E+E Elektronik develops and manufactures sensors, transmitters, hand-helds and data loggers for relative humidity, moisture in oil, dew point, air velocity, flow, CO2, temperature and pressure. E+E operates a nationally accredited calibration lab and is appointed to maintain the National Standard for Humidity and Air Flow Speed in Austria.
Humidity sensors and transmitters for process control, HVAC, OEM and mass applications
Dew point sensors / transmitters with auto-calibration for the measurement of low dewpoints.
Moisture in Oil
Oil condition sensors for moisture measurement in insulation, lubrication, transmission and hydraulic oils.
Dual wavelength NDIR CO2 measurement for demand controlled ventilation and process control
Air flow measurement for climatic and clean room technology based on the anemometer principle.
Thermal mass flowmeter for compressed air and non-corrosive gases.
Temperature sensors and transmitters for HVAC and process control.
Multi-range, user configurable differential pressure sensors
Accredited calibration services for humidity, dew point, CO2, air velocity, mass flow, temperature and pressure.
E+E Elektronik to Provide National Measurement Standard for CO2 Gas Concentration
The calibration laboratory of sensor specialist E+E Elektronik has been commissioned by the Austrian Federal Office of Metrology and Surveying (BEV) to provide the national measurement standard (etalon) for CO2 gas concentration. This makes the calibration experts from Engerwitzdorf the highest metrological authority in the country for a further physical quantity following humidity, dew point and air velocity. As the BEV's designated institute, E+E Elektronik is authorised to perform special calibrations at the level of a national metrology institute for these physical quantities.
Humidity and Temperature Sensor with Interchangeable Sensing Module
The EE212 humidity and temperature sensor by E+E Elektronik is suitable for challenging measurement tasks in climate technology, agriculture and the pharmaceuticals industry. Thanks to the modular probe design the sensing module can be easily replaced directly on site if needed. E+E sensor coating, the wide choice of filter caps, and the robust IP65 / NEMA 4 enclosure ensure accurate and reliable measurements even under challenging working conditions.
Modular Sigma 05 Sensor Platform with Interchangeable Sensing Probes
The Sigma 05 acts as a sensor hub for E+E Elektronik’s intelligent Modbus probes. It makes it easy to set up a modular sensor platform with up to three probes and five measurands. The Sigma 05 supports E+E sensing probes for CO2, humidity, temperature, ambient pressure and air velocity, making it suitable for a wide range of applications.